Sizing Conversion

 

BRACELET SIZE

Untitled-2.png

You may refer to the chart below for a basic guideline to bracelet sizes. Please note that this is an approximate measurement. Follow the steps below for a more accurate measurement.

HOW CAN I FIND MY BANGLE SIZE PRACTICALLY?

To determine your bangle size, follow these steps:

Untitled-3.png

 

STEP 1: Close your fingers together and bring your thumb to your little finger (as pictured). Pretend that you were putting on a bangle

STEP 2: Using a strip of paper or tape measurements, wrap it around your hand at the widest point.. If you are using a plain strip of paper, mark your size with a pen on that paper. Then measure that paper strip with a ruler. That would be the circumference of your hand.

STEP 3: Compare your hand circumference to the chart below. Purchase a bangle with diameter that is the next size up from your actual hand measurement.

 

Do you want a snug or loose fit? Well, that really will vary between each individual. If you are buying a delicate bracelet with a thin chain, we suggest doing a snug fit. Most other bracelets should have a comfort fit except when buying large or thick cuffs or bangles. It's best to buy large bracelets with a loose fit so you don’t feel like you are suffocating your wrist.

 

RINGS

Choosing the right ring size

The size you choose should allow the ring to be snug enough on your finger to ensure it will not fall off. The ring should be able to slide over your knuckle without having to use too much force.

Please note, finger size varies at different times of the day and due to changes in weather. It is best to:

· Measure your finger when your hand is warm.

· Measure your finger at the end of the day.

· Measure your finger several times to ensure the size is correct.

 

Measure Without a Ring

*Make sure you are measuring the finger you intend to wear the ring on. Alternatively, you use a tape measure directly on your finger. Refer to size chart below for your size. **Always refer to the   Centimeter/Millimeter   side because it is the most accurate on rings.  Put the ring on a ruler (centimeter side). Make sure it sits from 0 and that you are measuring the inside diameter not the outside. Refer to size chart below for your size.

*Make sure you are measuring the finger you intend to wear the ring on. Alternatively, you use a tape measure directly on your finger. Refer to size chart below for your size.
**Always refer to the Centimeter/Millimeter side because it is the most accurate on rings.

Put the ring on a ruler (centimeter side). Make sure it sits from 0 and that you are measuring the inside diameter not the outside. Refer to size chart below for your size.

Size Chart

 

NECKLACE

Untitled-8.png
Untitled-1.png